56cm ripper.
Frame:
Cinelli Mash Work- 56cm
Fork/Headset:
Cinelli Mash work / Chris King noThreadset
Crankset/Bottom Bracket:
Sugino 75 / phil wood 110.5
Pedals:
mks sylvan
Drivetrain/Cog/Chainring/Chain:
EAI 17T cog / Sugino 75 49T ring / KMC chain
Saddle/Seatpost:
Selle Italia flite, Thomson Masterpiece post and, Thomson clamp.
Brakes:
TRP cx 8.4 brakes
Front Wheel/Hub/Tire:
h plus son tb 14 / miche track low flange - some normal wear to ano on brake surfaces.
Rear Wheel/Hub/Tire:
h plus son tb 14 / miche track low flange - some normal wear to ano on brake surfaces.
More Info:
Small rust spot on top tube, pictured. These are raw, clear coated frames, and MASH always knew they would eventually rust and need to be re-painted. However, the clear is holding up remarkably well, save for this small area. You could easily sand it down and re-clear over this one section.
Added by colinatx. Last updated over 5 years ago.
14 Comments
Do you still have this? I will buy asap if you do
Posted about 7 years ago
apologies, sold a while ago. But I do have the same bike in 56cm same build that I could consider parting with complete. message me if interested.
Posted about 7 years ago
Hello, no chainline problem whit a Sugino 75 and a 110,5mm Phil wood bb?
Posted about 8 years ago
I haven't had a problem, as you can adjust the L/R position with a phil bracket. This was the recommended width for sugino 75s based on emails with Phil Wood back in 2009.
Posted about 8 years ago
Sounds good!! I have a 111mm Phil Wood bb, do you think it will be fine anyway?
Posted about 8 years ago
Photos
citycyclist247 says:
Hey how tall are you? I just got a 54 cm , if it doesn't work out I'll be looking for the next size up(non smoke edition).
Posted almost 7 years ago
colinatx says:
5'11". I usually ride a 54cm frame in everything else (road and cross, past track bikes), but the 54cm was def too small, fit more like a 52. If yours is too small would be happy to sell you this one complete! DM me.
Posted almost 7 years ago