Aventon MATARO

austinfbarlow says:

Yes, your cranks aren't determined by your frame, it is spindle length of your bb and what face the spindle has(square taper or spline), for Sugino 75 you need a 109mm spindle length and square taper bb.

Posted over 10 years ago

adamrides4ever says:

so the tange-seiki 109mm ISO sealed-cartridge bottom bracket,would fit my mataro low right?

Posted over 10 years ago

wuwu_startrack says:

any 68mm，english threaded BB will fit your mataro low. however, you need to figure out what crank and hub you are going to use than get a proper spindle length.

Posted over 10 years ago

adamrides4ever says:

ima get the sugino 75

Posted over 10 years ago

wuwu_startrack says:

if you like sealed bearing BB, i recommend this
https://www.benscycle.com/p-164-protype... , it is cheaper and works very good.

Posted over 10 years ago

adamrides4ever says:

thank you for help

Posted over 10 years ago

wuwu_startrack says:

hi there, i am 180cm

Posted over 10 years ago

wuwu_startrack says:

recently, i running a 120 -12 stem with a compact handle bar. if i use normal handle bar i would install a 110 -17 stem. thanks

Posted over 10 years ago

wuwu_startrack says:

thanks

Posted over 10 years ago

aberbrawler says:

ohhhh... and sweet build!

Posted almost 11 years ago

wuwu_startrack says:

use tubular tape on the seatpost

Posted almost 11 years ago

aberbrawler says:

interesting.. ill see how that goes

Posted almost 11 years ago

wuwu_startrack says:

try it， and you will know：）

it is very useful， i use velox tubular tape on the seatpost。

Posted almost 11 years ago